How to play flute: from the head joint to your first note
This lesson is built on Essential Elements for Band, Flute Book 1, a band method that starts the flute on the head joint alone, before any keys. It then moves on one note at a time, and every step pictured below is from it.
Blow across the top of an empty bottle and you have already played the flute’s kind of note. The flute works the same way, with a hole in a metal tube in place of the bottle neck. That hole sits on the head joint, the short piece with no keys, and learning how to play flute begins there for the first few days.
This guide follows the first pages of the Essential Elements band method. You find your first sound on the head joint alone, then learn the parts, how to put the flute together and line it up, how to hold it and your first note. After that come a practice plan for the first month, a table for fixing the sound, and how to clean a flute after every session.
To play the flute, start on the head joint alone. Rest the lip plate on your lower lip and roll it until your lip covers about a quarter of the embouchure hole. Then blow a narrow stream of air partly into and partly across the hole on “too”. Once that gives a steady tone, put the flute together with the hole in line with the keys and play your first note.
How a flute makes its sound
A flute has no reed and no mouthpiece to buzz into. Your lips stay still and shape the air into a thin, flat stream. That stream hits the far edge of the embouchure hole and splits, part going into the tube and part over the top. The splitting makes the air inside the flute vibrate, and the vibration is the note.
So your mouth does two jobs at once: it aims the air at that edge, and it controls how fast the air moves and how wide the stream is. A clarinet player gets a sound almost at once because the reed does the vibrating. A flute player has to find the angle first, so the first few days are spent on the head joint, where there are no keys to worry about.
How to play flute on the head joint first
Before you take the head joint out of the case, find the airstream. Sit on the edge of a chair with your spine tall and your shoulders relaxed. Hold your palm in front of your mouth, breathe in deeply through the corners of your mouth without lifting your shoulders, and feel your waist expand. Then whisper “too” and let the air out slowly into your palm. Your tongue starts the air on the “t”, and the “oo” keeps the lips small and relaxed.
Now pick up the head joint, the short piece with the hole in it. Essential Elements sets up the flute embouchure in seven short steps.
- Hold the closed end of the head joint in your left hand and cover the open end with your right palm.
- Rest the embouchure plate, the flat lip plate around the hole, on your lower lip. Center the hole on the center of your lips. To check, touch the hole with the tip of your tongue.
- Roll the head joint gently forward until your lower lip covers about a quarter of the hole.
- Keep your upper and lower teeth slightly apart.
- Draw the corners of your mouth straight back and let your lower lip relax.
- Make a small opening in the center of your lips and blow, so the air goes partly into the hole and partly across it.
- Practice in front of a mirror, rolling the head joint in or out a little until the tone is clear and full.
The first sounds are often mostly air with a faint note inside. Keep the opening between your lips small and the stream steady, and change the roll only in tiny steps. A whistle that is clear for even one second means the angle is close. With your palm over the end the head joint plays a low note, and with the end open it plays a higher one, so try both.
The book calls the next drill the Mouthpiece Workout. On the flute the mouthpiece is the head joint, so this is a long, even tone on “too”, a rest, and the same again.
Rest as long as you play. Blowing a lot of air with nothing to resist it can make you light-headed, and a short break clears that. Some teachers keep students on the head joint for a week or more before the whole flute comes out, and a few minutes a day is enough.
Essential Elements for Band, Flute Book 1 starts exactly here, with the head joint on page 2, then assembly and holding on page 3 and the first note on page 4. After that it adds one note at a time with short exercises and tunes. Band classes use it, and so do adult beginners, who can follow it at home page by page. Each copy also comes with online videos for the lessons marked with a play icon.
Parts of a flute
A concert flute comes in three pieces: the head joint, the middle joint (also called the body) and the foot joint. The picture from Essential Elements names them on a student flute, with the head joint on the left.
| Part | Where it is | What it does |
|---|---|---|
| Crown | The cap on the closed end of the head joint | Holds the cork inside the head joint in place. Leave it screwed on, since moving the cork changes the tuning. |
| Embouchure plate (lip plate) | Head joint | The flat plate that rests on your lower lip. |
| Embouchure hole | In the middle of the lip plate | The hole you blow across. Its far edge splits the air and makes the sound. |
| Head joint | The short, keyless first section | Makes the tone. Sliding it in or out of the body tunes the flute. |
| Middle joint (body) | The long center section | Holds most of the keys, with the left hand nearer your mouth and the right hand further along. |
| Keys and rods | Along the middle and foot joints | The keys close and open the tone holes; the rods link them, so one finger can move several keys. |
| E♭ key | Where the middle joint meets the foot joint | Pressed by the right little finger for almost every note, which also steadies the flute. |
| Foot joint | The short last section | Carries the keys for the lowest notes and the long rod you line up during assembly. |
How to assemble a flute
Wipe the ends of each joint with a soft cloth, then put the flute together in two twists. Hold every piece by its bare tubing. Squeezing the keys or rods while you push can bend them, and a bent rod leaves keys that do not close.
- Hold the head joint in your left hand and the middle joint in your right, by the plain section at its top. Twist the head joint gently into the middle joint.
- Turn the head joint until the center of the embouchure hole lines up with the center of the row of keys on the middle joint.
- Hold the middle joint in your left hand and the foot joint in your right, by its end below the keys. Twist the two together gently.
- Turn the foot joint until its long rod points at the center of the last key on the middle joint. Players fine-tune this to fit their right little finger, but the center is the usual place to start.
The diagram shows both lines, seen from above as you would look down at the flute.
The joints of a metal flute are made to slide together dry. Never put cork grease or any other grease on them, because dirt sticks to grease and a dirty joint can jam. If a joint feels tight, wipe both ends clean and twist again. A joint that still will not move belongs with a repair shop.
How to hold a flute
The flute rests on three points, and your fingers stay free to move. The book’s steps 3 to 5 set up the hands:
- Left thumb on the long, straight key on the underside, wrist straight, fingers arched, fingertips resting on the centers of the keys.
- The tip of the right thumb under the flute, between your first and second fingers. Arch the fingers, rest them lightly on the keys, and put your little finger on the E♭ key.
- The embouchure plate pressing lightly against your lower lip.
Those three contacts carry the weight: your chin and lower lip, the base of your left index finger, where the flute sits on the soft pad rather than the knuckle, and your right thumb. The right little finger on the E♭ key keeps the flute from rolling. Press the keys with the pads of your fingers, curved the way your hands hang at your sides. Very straight fingers move slowly, and fingers curled onto their tips tire fast.
The photo from Essential Elements shows the hold from behind, which is the view you cannot see in a mirror. The left hand comes across in front of the face, the right arm reaches out to the side, and the flute runs out to the right.
Sit on the front edge of the chair or stand tall, and bring the flute up to your lips instead of leaning your head down to it. The flute sits close to level. A slight droop toward the foot is normal, and your head can tilt a little to the right to follow it. Keep your shoulders down and your elbows away from your body, so your chest has room to breathe.
Your first note: F
Essential Elements starts the flute on F, the note on the top line of the staff, played as a long tone. Put your left thumb on its key, press the three left-hand keys and the first right-hand key, and keep your right little finger on the E♭ key. Then set the embouchure exactly as you did on the head joint and start the note with “too”.
If the note jumps up and sounds thin, slow the air down and let your lower lip relax. If you hear mostly air, make the opening between your lips smaller. The flute changes octave with the air alone, so a note that lands an octave too high or too low usually means the air speed is off and the fingering is fine.
From F the book walks down one note at a time to E♭, D, C and the B♭ on the middle line. Some teachers of adult beginners start on B, A and G instead, which add one left-hand finger at a time. The flute fingering chart shows the keys for both paths and for every other note up to high C.
A practice plan for the first month
Short, frequent sessions work best while the lip muscles get used to the embouchure. Start with 10 to 20 minutes and stop when your lips tire or the tone turns fuzzy. Over the month, work up to 20 or 30 minutes a day. A session can run like this:
- Two or three palm breaths on “too”, then the head joint workout: long tones and rests, with the end covered and open.
- Long tones on the whole flute, starting with F, each followed by a rest of the same length.
- The newest note from your book and the exercises that use it.
- A tune you like, to finish.
Among the lessons with a play icon in the book are the first sound, putting the flute together and the first note. Each icon points to a video on Essential Elements Interactive (EEi), where a flutist shows the step and play-along tracks put a band behind you for the exercises. You sign up with the access code printed in the paper book, and no school or teacher is needed.
Check your pitch now and then against an A on the tuning drone while you hold a long note. If you sound low, push the head joint a little further into the body; if you sound high, pull it out. A metronome keeps the exercises steady once they have a beat.
Three notes are enough for a first tune. Hot Cross Buns needs only B, A and G, and Mary Had a Little Lamb uses the same three notes plus D. The ten flute songs for beginners pick up from there.
When the sound is not right
On the flute, the usual culprits in the first month are the angle of the air and the size of the opening between your lips. Listen first, then look in the mirror.
| What you hear or feel | Likely cause | The fix |
|---|---|---|
| Only air, no note | The air misses the far edge of the hole, or the lip opening is too wide | Make the opening smaller and roll the head joint in or out in tiny steps |
| A note with a lot of hiss around it | Too much of the hole is open, or the stream is too wide | Let your lower lip cover about a quarter of the hole and keep the corners of your mouth back |
| A high squeak in place of the note | The air is too fast or the lips are pinched | Relax the lips and blow slower, as if fogging a window |
| A small, thin tone | Teeth closed or the lip plate pressed hard into the lip | Keep the teeth slightly apart and let the plate rest lightly on the lip |
| Feeling dizzy | Too much air in a row, with no rests | Rest after every long tone and breathe normally for a moment |
| The flute slides or rolls while you play | The weight sits on the fingertips instead of the three balance points | Rest the flute on the base of the left index finger and the right thumb, little finger on the E♭ key |
| A sore neck after practice | Leaning the head down to the flute | Sit tall and bring the flute up to your lips |
How to clean a flute
A flute picks up moisture inside from your breath and oil outside from your fingers. A dry swab after each session keeps the pads and the finish in good shape; the routine is on the first page of Essential Elements.
- Twist the head joint off and shake out any water.
- Thread a corner of a clean, soft, lint-free cloth through the slot of the cleaning rod and wrap the rest around the rod so no metal shows.
- Swab the head joint from the open end only. Pushing the rod hard against the closed end can move the cork.
- Twist the middle and foot joints apart and draw the wrapped rod through each one.
- Wipe the outside of each section with a soft or microfiber cloth to take off fingerprints, then put each piece in its place in the case.
A flute needs no oil and no grease from you. Oil on the keys or pads collects dirt and makes the pads stick. Keep liquids out of the tube too, since the pads are felt and skin that swell when wet. If a pad sticks or a key stops closing, take the flute to a repair shop. The springs and pads need a technician’s tools, and a bent key is easy to make worse.
Frequently asked questions
Is the flute hard to learn?
Getting the first sound takes the longest, since blowing across a hole is a new skill and the angle can take some days to find. The fingerings for the first notes are simple, and the second octave reuses most of the first. Tone and breath control keep improving for months if you practice a little on most days.
Why does my flute sound airy?
Usually because part of the air misses the far edge of the embouchure hole. Make the opening between your lips smaller, let your lower lip cover about a quarter of the hole, and roll the head joint in or out in tiny steps. Check that the hole lines up with the keys, since a head joint turned too far makes the angle hard to find.
Can you teach yourself the flute as an adult?
Yes. Essential Elements and its online lessons show each step, and an adult can follow the book at home as easily as a student in band. The embouchure is the part that is hard to judge alone, so a few lessons early on are worth having to correct it before a habit sets in.
How long should a beginner practice the flute?
Start with 10 to 20 minutes a day and stop when your lips tire. Work up to 20 or 30 minutes over the first weeks. Several short sessions in a week build the embouchure better than one long one, and resting between long tones keeps you from getting dizzy.
Do you need to oil or grease a flute?
No. A metal flute’s joints fit together dry, and grease on them traps dirt and can make them stick. Oil on the keys or pads does harm too. Swab the flute dry after playing, wipe the joints clean, and leave oiling the mechanism to a repair technician.
Begin on the head joint
Open each session on the head joint and stay there until the tone is steady. Then put the flute together with the hole in line with the keys and hold a long F, resting as long as you played. E♭, D, C and B♭ follow on the fingering chart. For a first tune, learn B, A and G and play Hot Cross Buns.
After F, Essential Elements for Band, Flute Book 1 brings in E♭, D, C and B♭ one at a time, each with a short exercise and an online recording.
View scores on MuseScore
Rate this article
Be the first to rate this article